Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and Installing/Replacing Armrest for Rear Seat Backrest (Through-Loading System)
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing Armrest for Rear Seat Backrest (Through-Loading System)
52 26 030 - Removing and installing/replacing armrest for rear seat backrest (through-loading system)
Fold down right backrest.
Feed out top cover (1) or detach from armrest (2).
Release screw (3).
Tightening torque: 52 26 4AZ Rear Seats (Through-Loading System).
Feed armrest first forwards and then to right out of left backrest mount (4).
Important!
Cover must not be trapped during installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.