Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERSERVICE AND REPAIR
2008 BMW M5 (E60) V10-5.0L (S85)
Front Fender: Service and Repair
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair
41 35 000 Removing and installing/replacing side panel, front left or right
For stripping and rigging operations, refer to texts on KSD CD (FR number 41 35 000).
CAUTION: Do not damage adjoining body parts.
Installation information: Gap dimensions serve as basis for adjustment tasks.
Inner view of front side panel with holders.
Remove screws and nuts.
Replacement:
Also apply sprayable sealing compound on inside of side panel in area (1). Width approx. 50 mm.
Material: Terostat 9320 (sourcing reference: BMW Parts Service).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.