Removing and Installing/Replacing DVD Drive for Car Communication Computer

65 83 580 - Removing and installing/replacing DVD drive for Car Communication Computer





Special tools required:
- 00 9 450 00 9 450 Torque Wrench
- 12 7 192 12 7 190 EPROM Tools / ID Marking
- 64 1 020 64 1 020 Release Hook





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).

Risk of damage!

Place Car Communication Computer on special tool 12 7 192 12 7 190 EPROM Tools / ID Marking (antistatic mat) and earth/ground.





Necessary preliminary tasks:
- Remove front trim for Car Communication Computer Removing and Installing/Replacing Front Trim for Car Communication Computer





If necessary, cut through warranty seal.

Raise cover (1) with special tool 64 1 020 64 1 020 Release Hook all round and remove from Car Communication Computer (2).





Release bolts (1).

Feed out bridge (2).

Installation Note:
Use special tool 00 9 450 00 9 450 Torque Wrench to tighten down screws.

Tightening torque 65 11 3AZ [1][2]Radio, Stereo, and Compact Disc.





Cut through stickers at marked points (1).

Release screws (2) and remove trim (3).

Installation Note:
Use special tool 00 9 450 00 9 450 Torque Wrench to tighten down screws.

Tightening torque 65 11 3AZ [1][2]Radio, Stereo, and Compact Disc.





Release screws (1) with magnetic screwdriver.

Installation Note:
Lug (2) of DVD drive must be above lug (3) of Car Communication Computer.





Turn Car Communication Computer through 180° and carefully feed out DVD drive.

Carefully disconnect plug connections (1, 2).

Remove DVD drive (3).

Installation Note:
Ensure correct cable routing.





After installation:

On cars before March 2006 it is essential after replacing the DVD drive to carry out a measures plan or a software update as per SSS/Progman/CIP Programming and Relearning.