Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and Installing/Replacing Headphones Module
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing Headphones Module
65 12 250 - Removing and installing/replacing headphones module
Necessary preliminary tasks:
- Disconnect battery negative lead Disconnecting and Connecting Battery Negative Lead
- If necessary, remove emergency wheel
Take off cover for control units (1).
Installation:
Make sure cover for control units (1) is correctly seated on locating pins (2).
Note:
Illustrations show removal from the E60.
Unfasten plug connection (1) and disconnect.
Remove headphones module (2) upwards out of mounting for control units (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.