Antitheft Motion Sensor: Service and Repair

2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair



65 75 071 - Removing and installing/replacing module for passenger compartment sensor





Special tools required:
- 00 9 340 00 9 340 Disassembly Aid (2 Pieces)





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge)!





Lever out trim (1) with special tool 00 9 340 00 9 340 Disassembly Aid (2 Pieces) and remove.





Disconnect plug connection (1) and remove module for passenger compartment sensor with trim.

Replacement:

Open retaining lugs (2) and remove module (3).

Installation Note:
Arrow (4) printed on module for passenger compartment sensor must be aligned in direction of arrow.





Replacement:

Carry out programming/coding Programming and Relearning.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.