Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
65 90 550 Replacing CD/DVD drive for navigation computer
Special tools required:
- 00 9 318
Comply with notes and instructions on handling navigation computers, see 65 90 ... Notes on handling navigation computers .
Replace the destroyed seal on all devices with the new seal supplied.
Necessary preliminary tasks:
- Remove navigation computer, see 65 90 511 Removing and installing (replacing) navigation computer with CD drive .
MK II version:
Cut through seal (1).
Release screws (2) on both sides and carefully fold down front panel (3).
Installation:
Replace the destroyed seal with the new seal supplied.
Lever cover (1) with special tool 00 9 318 upwards out of side catches.
Release screws (1) and carefully lift out CD drive (2).
MK III and MK IV versions:
Cut through seal (1).
Carefully lever off cover (2) with special tool 00 9 318.
Installation:
Replace the destroyed seal with the new seal supplied.
MK III version:
Release screws (1) and carefully lift out drive (2).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.