Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2007530XI 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 78 (ENGINE CONTROLS - BASIC DIAGNOSTIC PROCEDURES)FUEL SYSTEMFUEL PRESSURE TESTFUEL PRESSURE RELATED PROBLEMS
2007 BMW 530xi 4D Sedan, Standard
Fuel Pressure Related Problems
2007 BMW 530xi 4D Sedan, StandardSECTION Fuel Pressure Related Problems
WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 2003 BMW Z8, 2003 BMW Z4, 2003 BMW X5, 2003 BMW M5, and 2003 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
- Drive Characteristic Faults, Lack Of Power:
Run engine at idle speed and measure fuel pressure. If measured value is less than the nominal value of - 2.9 psi (- 0.2 bar), line cross-sections in fuel feed are constricted or fuel filter is clogged, or fuel pump voltage supply is not okay because of possible high contact resistance (corrosion) in plug connection between wiring harness and fuel pump. If the measured value is greater than the nominal value of 2.9 psi (0.2 bar), turn off engine and then observe measured value. If measured value drops to nominal value, then line cross-sections in fuel return are constricted or clogged. Check fuel lines for kinks. It no kinks are visible, replace return lines. If measured value remains too high, then pressure regulator is in all probability faulty.NOTE: It is less likely that return line may be completely blocked. When pressure regulator is removed, fuel could escape under pressure. Have a clean cloth ready and catch and dispose of escaping fuel. Replace return line but not the pressure regulator.
- Starting Problems:
Run engine briefly at idle speed, then switch off. Note measured value while engine is stopped. Read off measured value again after about 20-30 minutes while engine is stopped. If the measured value has dropped by more than 7.2 psi (0.5 bar), start engine and wait briefly for a stable pressure increase. Switch off the engine and immediately pinch off the delivery line just before the pressure gauge with Hose Clamp (133010). Note measured value. Read off measured value again after about 20-30 minutes while engine is stopped. If measured value has now dropped by less than 7.2 psi (0.5 bar), the following faults can be present:
- Fault in delivery lines.
- Fault in in-tank delivery hose.
- Faulty pressure-holding non-return valve in fuel pump. Check components and replace as necessary.
- If the measured value has dropped by more than 7.2 psi (0.5 bar) again, replace pressure regulator. All fuel hoses and hose clips which were detached within the framework of the checks must be replaced. Interrogate fault memory of DME control unit. Check for stored fault messages. Rectify faults and clear fault memory.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.