Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition Coil Secondary Signal Check
2007 BMW 530xi 4D Sedan, StandardSECTION Ignition Coil Secondary Signal Check
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1998 BMW Z3, 1998 BMW M3, 1998 BMW M Roadster, 1998 BMW 740iL, and 1998 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
- Connect engine analyzer and Adapter (127020) as described in IGNITION COIL PRIMARY SIGNAL CHECK
. Remove ignition coil. Connect a spark plug wire (between coil and spark plug) to cylinder being tested. Connect inductive pick-up Blue lead, on lead to cylinder being tested. See Fig 1
.IGNITION COIL RESISTANCE - Ohms @ 68°F (20°C)
Primary Secondary .8 (1) Not Measurable (1) Specification is approximate - Produce stopped signal on oscilloscope by pressing "R" button on tester. Display of ignition signal on oscilloscope will be strongest when inductive clip and Black lead are connected to same cylinder. Display on oscilloscope may be disturbed by neighboring ignition leads (this is normal).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.