Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 196 Removing and installing (replacing) control unit for automatic operation of tailgate system
Necessary preliminary work
- DISCONNECT NEGATIVE BATTERY CABLE .
- Remove both battery earth leads at F03.
- Remove right LUGGAGE COMPARTMENT WHEEL ARCH PANEL .
- control unit to 09/2010
- control unit from 09/2010
Replacement:
Control unit (2) is installed as shown in vehicles with a production date up to 09/2010.
Disconnect plug connection (1).
Pull out control unit for automatic tailgate activation (2) in direction of arrow.
Replacement:
Carry out VEHICLE PROGRAMMING AND ENCODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.