Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 107 Removing and installing or replacing junction box electronics
Necessary preliminary work
- Partially remove POWER DISTRIBUTION BOX FOR PASSENGER COMPARTMENT .
Release screws (1) on junction box electronics (2).
Tightening torque 61 14 2AZ .
Disconnect plug connection (1).
Pull junction box electronics (2) out of bracket.
Installation note:
Make sure junction box electronics and plug connections (1) are correctly seated.
Replacement:
Carry out VEHICLE PROGRAMMING/CODING .
Delete transport mode.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.