Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2007530XI 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2209 (MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS)MAINTENANCE AND GENERAL DATA00 0 280 FILM SHEET AND HOOK SETS FROM SPECIAL TOOL BOARD VII
2007 BMW 530xi 4D Sedan, Standard
00 0 280 Film sheet and hook sets from special tool board VII
2007 BMW 530xi 4D Sedan, StandardSECTION 00 0 280 Film sheet and hook sets from special tool board VII
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
In conjunction with: 00 0 224 or appropriate number 00 0 241
NOTE:
For retrofitting onto special tool boards. NOTE: Each film with hook set is always supplied in accordance with the current status of the special tools. Up to three films can be stuck onto a large special tool board.
Order number: 00 0 280
Film sheet and hook sets from special tool board VII
Consisting of:
1 = 00 0 281 Film sheet and hook set
NOTE:
For fields A/B/C - 41 and 42
2 = 00 0 282 Film sheet and hook set
NOTE:
For fields A/B/C - 43 and 44
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.