Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 71 371 Removing And Installing/Replacing Tension Strut On Left Or Right Spring Strut Dome
2007 BMW 530xi 4D Sedan, StandardSECTION 51 71 371 Removing And Installing/Replacing Tension Strut On Left Or Right Spring Strut Dome
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 120
IMPORTANT:
Risk of damage!
Driving without the tension strut is not permitted as otherwise the body may be damaged.
Tension strut screws must be tightened to torque and then tightened down with special tool 00 9 120.
Driving without the tension strut is not permitted as otherwise the body may be damaged.
Tension strut screws must be tightened to torque and then tightened down with special tool 00 9 120.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.