Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2007530XI 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1344 (FRONT AXLE - REPAIR)
2007 BMW 530xi 4D Sedan, Standard
Section 1344 (Front Axle - Repair)
2007 BMW 530xi 4D Sedan, StandardSECTION Section 1344 (Front Axle - Repair)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
- 00 General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 00 ... ... Raising vehicle with trolley jack
- 31 .. .. Layout of spring strut shock absorber
- 31 .. ... Front axle overview
- 31 00 ... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
- 31 00 ... Information on replacing shock absorbers
- 31 00 ... Notes on repairing threads
- 10 front axle suspension
- 11 front sub-frame
- 12 struts with rubber mounts
- 31 12 000 Removing and installing/replacing left or right control arm
- 31 12 003 Removing and installing / replacing top right wishbone
- 31 12 023 Measuring play of wheel control joints
- 31 12 024 Replace wheel control joint in wishbone (all-wheel drive vehicle
- 31 12 026 Removing and installing/replacing guide joint in swivel bearing
- 31 12 050 Removing and installing/replacing left or right tension strut
- 31 12 135 Replacing rubber mounts on both control arms
- 31 12 138 Replacing rubber mounts on both tension struts
- 31 12 640 Replacing rubber mounts in both control arms (control arms removed)
- 21 wheel bearings and stub axle
- 31 spring strut
- 33 spring with suspension
- 35 stabilizer bar
- 50 front axle gearbox
- 51 Seal and O-Rings
- 53 differential with bearings
- 60 output shaft
- 31 60 ... Pressing output shaft out of drive flange (wheel hub) and drawing in
- 31 60 000 Removing and installing/replacing left or right output shaft
- 31 60 530 Replacing an output shaft gaiter (on transmission side) (output shaft removed)
- 31 60 535 Replacing both gaiters on left and right of output shaft
- 90 troubleshooting
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.