Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 795 Removing And Installing (Replacing) Control Unit For Adaptive Headlight
Necessary preliminary tasks:
- Remove safety information module . See 65 77 700 REMOVING AND INSTALLING (REPLACING) SAFETY INFORMATION MODULE .
Unfasten plug connection (1) and disconnect.
Unlock catch (2) in direction of arrow.
Pull control unit for adaptive headlight (3) out of equipment carrier (4) and remove.
Replacement:
Carry out programming/coding. . See VEHICLE PROGRAMMING AND CODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.