Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2007328I 2D COUPE, N52, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSGENERAL ELECTRICAL SYSTEM - REPAIR - E92/E93PLUG CONNECTION, TERMINALS, FUSE BOX61 13... TREATING CABLES AND FIBRE-OPTIC CABLES
2007 BMW 328i 2D Coupe, N52, Automatic
61 13... Treating cables and fibre-optic cables
2007 BMW 328i 2D Coupe, N52, AutomaticSECTION 61 13... Treating cables and fibre-optic cables
- 61 1 190
- 61 4 320
NOTE:
Special tools referred to in the repair instructions below are contained in the following special tool kits:
SPECIAL TOOLS CHART
| Repair range for vehicle electrical system | |
| Crimping set with tool for fibre-optic cables, Micro Power Quadlock (MPQ), Micro Quadlock System (MQS) contacts and universal crimping head | 61 4 320 |
| Insulation displacement tool for ribbon cable | 61 1 190 |
Subject of repair instructions
- SPECIAL TOOLS FOR WIRING HARNESS REPAIRS
- CUTTING TO LENGTH AND STRIPPING INSULATION FROM CABLES
- CRIMPING STOP PARTS (CONTACTS)
- BUTT CONNECTOR FOR REPAIRING A PLUG CONNECTION
- FAN CONNECTOR FOR RETROFITTING/REPAIRS
- Aerial elbow plug on radio receiver
- CUTTING TO LENGTH AND STRIPPING INSULATION FROM OPTICAL FIBERS
- CRIMPING OPTICAL FIBRES
- Insulation displacement connector for REPAIRING RIBBON CABLES
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.