Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 12... General information on intelligent battery sensor (IBS)
The cigarette lighter is powered by the rear distribution box via a relay. This relay drops out after terminal 15 OFF. This means that a continuous trickle charger connected to the cigarette lighter is disconnected from the battery.
Charge the battery via the jump-start connection points. Only then can the power supply be registered by the vehicle.
- Do not introduce any additional connections at the battery negative terminal.
- Do not modify the grounding cable.
The grounding cable also serves to dissipate heat.
- Do not establish any connection between the IBS and the sensor screw.
- Do not use force when disconnecting the pole shoe from the battery terminal:
- Do not pull on the grounding cable.
- Do not place any tools under the IBS to lever off the pole shoe.
- Do not use IBS connections as levers.
- Use a torque wrench and set tightening torque in accordance with repair instructions.
- Do not release or tighten down sensor screw (screw with Torx head).
- Avoid contact between IBS and ground.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.