SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2006X3 AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONOEM GENERAL INFORMATIONCODING AND PROGRAMMING - OVERVIEW - ALL MODELSCODING & PROGRAMMINGDME CONTROL MODULE PROGRAMMINGPROGRAMMING PROCEDURES FOR "EXCHANGE EPROM"
2006 BMW X3 Automatic

Programming Procedures for "Exchange EPROM"

2006 BMW X3 AutomaticSECTION Programming Procedures for "Exchange EPROM"

Select this to program a replacement control module EPROM.

Prior to any type of programming, make sure the DME fault memory is cleared and vehicle battery is connected to a BMW battery charger with stabalized 12.5V!

  1. From the Programming selection menu select "3 Exchange EPROM"  and press continue.
    Fig 1: View Of Programming Procedures For Exchange EPROM (1 Of 10)
    G03402983Courtesy of BMW OF NORTH AMERICA, INC.
  2. Press "1 Determine EPROM"  and press the enter button.
    Fig 2: View Of Programming Procedures For Exchange EPROM (2 Of 10)
    G03402984Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.