Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2006M5REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1713 (ENGINE - REPAIR)
2006 BMW M5
Section 1713 (Engine - Repair)
2006 BMW M5SECTION Section 1713 (Engine - Repair)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
- Engine, General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 11 00... Engine oil service
- 11 00 Removing and installing/replacing ignition coil cover
- 11 00 039 Checking compression in all cylinders
- 11 00 050 Removing and Installing Engine
- 11 00 670 Securing engine in installation position
- Engine identification
- Mounting engine on assembly stand
- Cylinder Head And Cylinder Head Cover
- Oil Sump
- Housing Cover
- Crankshaft With Bearing
- Flywheel
- Vibration Damper
- Connecting Rod With Bearing
- Piston With Rings And Pin
- V-Ribbed Belt And TENSIONER
- Camshaft
- Rocker Arm With Bearing Mount
- Valves With Springs
- Variable Camshaft Timing
- Oil Supply
- Oil Pump With Filter And Drive
- Oil Filter And Lines
- 11 42 020 Removing and installing/replacing full-flow oil filter
- 11 42 035 Removing and installing/replacing thermostat housing
- 11 42 198 Removing and installing oil feed line for exhaust turbocharger
- 11 42 248 Removing and installing/renewing the oil return line for exhaust turbocharger cyl. 1-3
- 11 42 250 Removing and installing oil return line for exhaust turbocharger
- Oil Cooler
- Water Pump With Drive
- Thermostat And Connections
- Intake Manifold
- Supercharger With Control
- Vacuum Pump
- Emission Control, Oxygen Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.