IMPORTANT: Risk of damage!

The navigation computer must not be disconnected from the power supply while the LED on the computer remains lit (the LED goes out after approx. 1 minute).

Software Installation:

The navigation software must be loaded with terminal 15 activated and the navigation system ready for operation.
Make sure there is a stable power supply. If necessary, connect a battery charger to the vehicle.
The charging operation must not be interrupted (terminal 15 remains activated).
The software is loaded when the operating software CD is ejected.

NOTE: To ensure full operation of all the communications components, it is necessary in new cars to insert a Road Map CD in the navigation computer.

This is absolutely essential as certain functions are disabled for distribution channels.

These functions will only be available again after a Road Map CD has been inserted. The mode preset at the factory is automatically reset when this CD is inserted.

When Replacing Navigation Computer:

Carry out programming/coding. Refer to DIAGNOSIS PROGRAMMING/CODING .

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

All model series

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?