Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Battery Safety Terminal
The BST is installed due the battery location in the luggage compartment. The BST is used to minimize the possibility of a short circuit to the heavy gauge B+ wire that runs the length of the vehicle in the event of an accident.
The BST consists of a conventional clamp that is screwed onto the positive terminal from above and connected with a hollow cylinder. A propellant charge is stored in this hollow cylinder. Just as with the airbag and seat belt pre-tensioner, this pyrotechnic device is controlled and ignited by the MRS5 control module. The triggering strategy is also the same as for the triggering of the airbag, and it possesses identical protection logic. The overall unit is enclosed in a plastic shell that captures the cable if it is forced out and locks it so that a renewed contact is no longer possible.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.