Neutral Detection, Position Switch (Functional Descriptions)

2004 BMW 325Ci Convertible (E46) L6-2.5L (M54)SECTION Neutral Detection, Position Switch (Functional Descriptions)



Selector Lever Switch

The EGS control unit detects the selector lever position by way of a switch on the transmission. This switch converts the current selector lever position into a code. This selector lever code is transferred via four lines (L1-L4) to the EGS control unit.

Selector lever position L1 to L4 (0 = open, 1 = U-batt)
P L1 =1, L2 = 1, L3 = 0, L4 =1
R L1 =1, L2 = 0, L3 = 0, L4 =0
N L1 =1, L2 = 1, L3 = 1, L4 =0
D L1 =0, L2 = 0, L3 = 1, L4 =0
4 (3) L1 =0, L2 = 0, L3 = 0, L4 =1
3 (2) L1 =0, L2 = 0, L3 = 1, L4 =1
2 (1) L1 =1, L2 = 0, L3 = 1, L4 =1
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.