SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2004320I (E46) (CANADA) L6-2.2L M54REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIRREPLACING MODULE FOR PASSENGER COMPARTMENT PROTECTION
2004 BMW 320i (E46) (CANADA) L6-2.2L M54

Replacing Module For Passenger Compartment Protection

2004 BMW 320i (E46) (CANADA) L6-2.2L M54SECTION Replacing Module For Passenger Compartment Protection



Removing And Installing/Replacing Module For Passenger Compartment Protection


NOTE:
Remove airbag control unit.
Remove right glovebox.
Remove panel for pedal assembly.
Remove all clip-fitted trims on panel for instrument panel.
Release panel for instrument panel.







Remove holder (1) towards front.
Detach insulating mat (2) towards rear.
Cut carpet (3) as illustrated and lay to one side.







Unscrew nut (1).
Raise module for passenger compartment protection (2) on right and pull in direction of arrow out of guide (3).
Disconnect plug connection (4).

Installation:
Ensure module for passenger compartment protection (2) is in correct installation position.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.