Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2004320I (E46) (CANADA) L6-2.2L M54REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLPARKING BRAKE SYSTEMPARKING BRAKE LEVERSERVICE AND REPAIR
2004 BMW 320i (E46) (CANADA) L6-2.2L M54
Parking Brake Lever: Service and Repair
2004 BMW 320i (E46) (CANADA) L6-2.2L M54SECTION Service and Repair
Removing and installing/replacing handbrake lever
Remove storage tray.
If necessary, remove center armrest.
Installation:
Adjust handbrake after completing work.
Follow adjustment instructions.
Disconnect lines to handbrake indicator switch.
Release adjustment nuts with special tool 00 2 222 and screw down fully from Bowden cables.
Installation: Use new screws.
Release screws (1 and 2).
Remove handbrake lever.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.