Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Park Distance Control: Introduction
The Park Distance Control is a safety/convenience system that uses ultra-sonic sensors to detect the close proximity to other objects when maneuvering the vehicle in tight spaces (such as parallel parking or parking in a narrow garage).
The PDC monitors both the front and rear of the vehicle. The driver is warned, through an audible gong system, when the vehicle comes close to another object. As the object gets closer, the audible gong increases in frequency until a steady tone is produced.
As the distance to the object increase, the steady tone will return to a beep and stop when the vehicle moves away from the object.
The PDC is automatically switched "ON" when the ignition is switched on. However it does not become active until the vehicle is shifted into reverse.
The system can be manually switched "ON/OFF' with the console mounted switch.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.