Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001530I AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM & COMPONENT TESTINGFUEL SYSTEMFUEL CONTROLFUEL INJECTOR CLEANING
2001 BMW 530i Automatic
Fuel Injector Cleaning
2001 BMW 530i AutomaticSECTION Fuel Injector Cleaning
- Remove fuel injectors. See FUEL RAIL & INJECTORS in REMOVAL & INSTALLATION article. Install injector valves in Holding Fixture (13 6 205). See Fig 1. Connect Harness (13 6 206) to injector valves and to a 12-volt battery. This removes remaining fuel from injector valves. Lay a clean cloth under injector valves to catch remaining fuel. Connect holding fixture to compressed air connection (maximum 44 psi). See Fig 2. Residual fuel is now blown out of injector valves.
- Separate Harness (13 6 206) from injector valves. Install injectors with holding fixture in a container with hot water at 140-176°F (60-80°C). See Fig 3. Regulate air pressure at connection on holding fixture to 44 psi. Note volume of air emerging from injectors. Permitted volume of air emerging from each injector is 2 air bubbles per injector within a 15-minute period. Injectors with a larger amount of air must be cleaned. Remove injectors from water and dry well with compressed air.
- Use Ultrasonic Cleaning Unit (13 6 200) to clean injector valves. Attach injector valves to cleaning unit with holding fixture. Fill cleaning unit with Cleaning Concentrate (13 6 207). See Fig 3. Perform cleaning procedure as specified by manufacturer. Perform leak test on cleaned injector valves. See FUEL INJECTOR LEAKAGE .CAUTION: Do not carry out leak test in cleaning concentrate but rather in a water bath.
- To remove preserving agent, rinse new injector valves with fuel only after about 5 minutes. Install injector valves immediately in engine and run engine. This flushes out any remaining cleaning concentrate, preventing injector valve corrosion. Due to the risk of corrosion, cleaned injector valves cannot be stored.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.