Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 BMW 330i AutomaticFACTORY OEM SERVICE PROCEDURE
Front (E65)
NOTE:
The camber must be adjusted first. See FRONT (E65) under CAMBER ADJUSTMENT.
- Move steering gear and wheels to straight ahead position. Markings on cap (1) and on housing (2) must match up on steering gear. See Fig 1.
- Loosen lock nut (1) on tie rod, gripping tie rod in so doing. Adjust wheel toe-in by turning tie rod axial joint at hexagon head (2). See Figure. Adjust to specification. See E65 under WHEEL ALIGNMENT SPECIFICATIONS.
- Make sure steering sleeve is not twisted. Grip tie rod and tighten down lock nut (1) to specification. See E65 under TORQUE SPECIFICATIONS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.