Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 41 500 Replacing idle speed control valve (M60, M62): Installation
Position acoustic cover and press downwards until press-studs (1 ... 4) click into place.
Unfasten plug connection (1).
Open clips (1), unfasten hose clip (2) and remove hose. Lift off upper section of air filter housing.
Unfasten hose clips (1) and (2).
Remove suction hoses with upper section of air filter housing.
Disconnect retainer (1).
Remove idle speed control valve.
Install sealing ring in throttle valve flange first.
To ensure that air intake unit is free of leaks, seals on throttle body and idle speed control valve are clean and not damaged. If the sealing rings are damaged, they must be replaced.
Interrogate fault memory of DME control unit, check faults in memory then cancel fault memory.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.