Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW1994530I (E34) V8-2997CC 3.0L DOHC (M60)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULETESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSENGINE TEMPERATURE SENSOR (COOLANT)
1994 BMW 530i (E34) V8-2997cc 3.0L DOHC (M60)
Engine Temperature Sensor (Coolant)
1994 BMW 530i (E34) V8-2997cc 3.0L DOHC (M60)SECTION Engine Temperature Sensor (Coolant)
Check function:
[D] 200 - The indicated engine temperature should correspond to the coolant temperature. A value below - 30 °C indicates a break in the temperature sensor or in the wire to the DME control unit.
Resistance test:
Connect universal adapter to the engine wire harness. Measure resistance over the terminals 45 and 19.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.