Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW1993740IL (E32/2) V8-3982CC 4.0L DOHC (M60)REPAIR AND DIAGNOSISTESTING AND INSPECTIONLABSCOPE QUICK REFERENCE APPENDIXTIME PER DIVISION VS. FREQUENCY CHART
1993 BMW 740iL (E32/2) V8-3982cc 4.0L DOHC (M60)
Time Per Division VS. Frequency Chart
1993 BMW 740iL (E32/2) V8-3982cc 4.0L DOHC (M60)SECTION Time Per Division VS. Frequency Chart
Chart For Determining Time Base Setting, Based On Signal Frequency:
PURPOSE OF THIS CHART: To assist in choosing time per division settings on the Digital Storage Oscilloscope (DSO) based on the signal's frequency, or to estimate the frequency of a signal on the DSO display.
HOW TO USE THIS CHART: Determine the frequency (Hz) of the signal by using the DMM function of the DSO. Take the frequency reading from the DMM, and round off to the closest number in the left column. Choose how many cycles of the signal you want to see on the DSO display at the same time and go over to that column. That is a good time base to begin with.
Additionally, you can estimate the frequency of the signal on your DSO by counting the number of cycles on the display (1 through 5), going to that column in the chart, and going down the column to find your current time base setting. The left column will estimate the frequency.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.