Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW1993740IL (E32/2) V8-3982CC 4.0L DOHC (M60)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONINITIAL INSPECTION AND DIAGNOSTIC OVERVIEWDIAGNOSTIC STRATEGIESSYSTEMATIC TROUBLESHOOTINGWIRE TESTINGSHORT TEST USING VOLTMETER
1993 BMW 740iL (E32/2) V8-3982cc 4.0L DOHC (M60)
Short Test Using Voltmeter
1993 BMW 740iL (E32/2) V8-3982cc 4.0L DOHC (M60)SECTION Short Test Using Voltmeter
Short Test Using Voltage:
Short Test Using Voltmeter:
1 Voltmeter
2 Switch for reversing light (OFF)
3 Connection to load disconnected
4 Rear light
5 Battery
A Short to ground
Measuring instrument: Voltmeter
Problem: Short to ground
Test Procedure:
Disconnect voltage source and connect voltmeter with test lead Disconnect the load. Move the lead to the load back and forth and observe the voltmeter reading. If the voltmeter registers a voltage there is a short to ground in the wiring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.