Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW1993740IL (E32/2) V8-3982CC 4.0L DOHC (M60)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEDESCRIPTION AND OPERATIONENGINE CONTROL SYSTEM VERSION ID BY MODELDME M3.3 (88 PIN CONTROL MODULE)
1993 BMW 740iL (E32/2) V8-3982cc 4.0L DOHC (M60)
DME M3.3 (88 Pin Control Module)
1993 BMW 740iL (E32/2) V8-3982cc 4.0L DOHC (M60)SECTION DME M3.3 (88 Pin Control Module)
This further developed system introduced CAN technology and Hot Film Air Mass Sensors to BMW automobiles.
QUICK VISUAL IDENTIFIERS:
88 Pin CM (M1.7):
Hot Film Air Mass Sensor:
Individual Ignition Coils:
SYSTEM FEATURES:
- Power Supply Control (ECM Main Relay)
- Full - Sequential Fuel Injection with individual fuel injector shut-off
- Fuel Pump Relay Control
- Secondary Air Injection control (530i/Ti)
- Cold Start Enrichment control
- O2 Sensor Heater Relay Control
- Direct, Solid State Ignition Timing Control with knock sensor monitoring
- Secondary Ignition Monitoring
- Output of Ti, TD and DK signals
- AC compressor relay control
- EGS communication via CAN
- ASC+T/ADS II system interface
- Substitute operating values employed if specific input signals become impaired.
- Fault monitoring with defect memory
- DIS/MoDiC Communication for Diagnosis and Programming
ADAPTIVE SYSTEM FEATURES:
- Adaptive ms injection time based on stereo O2 Sensor Signal(s) with memory
- Adaptive Idle Speed Control
- Adaptive Purge Valve Control 10
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.