Drive-Away Protection

1993 BMW 740iL (E32/2) V8-3982cc 4.0L DOHC (M60)SECTION Drive-Away Protection
OPERATION
When the drive-away protection function is activated on the on-board computer (code entered) or when the Antitheft system (DWA) is armed, a signal (> 10 V) is sent to the Digital Motor Electronic (DME) control unit which consequently switches off the ignition and injection.

This function can only be activated at an engine speed below approx. 500 rpm.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.