Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/C Compressor Servicing
1992 BMW M5SECTION A/C Compressor Servicing
- ATSUGI Rotary Vane Clutch Coil R & I
- BOSCH 6-Cylinder Clutch Coil R & I
- BOSCH 6-Cylinder Shaft Seal R & I
- CALSONIC V5 Clutch Coil R & I
- Diesel KIKI (ZEXEL) Rotary Vane Clutch Coil R & I
- Diesel KIKI 6-Cylinder Clutch Coil R & I
- Diesel KIKI 6-Cylinder Shaft Seal R & I
- Ford FX-15 Clutch Coil R & I
- Ford FX-15 Shaft Seal R & I
- HARRISON A-6 6-Cylinder Clutch Coil R & I
- HARRISON A-6 6-Cylinder Shaft Seal R & I
- HARRISON R4 4-Cylinder Clutch Coil & Bearing R & I
- HARRISON R4 4-Cylinder Shaft Seal R & I
- HARRISON V5 5-Cylinder Clutch Coil & Bearing R & I
- HARRISON V5 5-Cylinder Shaft Seal
- HITACHI 5 & 6-Cylinder Clutch Coil R & I
- HITACHI 5 & 6-Cylinder Shaft Seal
- MATSUSHITA Rotary Vane Clutch Coil
- NIPPONDENSO TV12 Rotary Vane Clutch Coil R & I
- NIPPONDENSO 6 & 10-Cylinder Clutch Coil & Bearing R & I
- NIPPONDENSO 6 & 10-Cylinder Shaft Seal R & I
- PANASONIC Rotary Vane Clutch Coil R & I
- PANASONIC Rotary Vane Shaft Seal R & I
- SANDEN Scroll Clutch Coil & Shaft Seal R & I
- SANDEN 5-Cylinder Clutch Coil R & I
- SANDEN 5-Cylinder Shaft Seal R & I
- SANDEN 7-Cylinder Clutch Coil & Bearing R & I
- SANDEN 7-Cylinder Shaft Seal R & I
- ZEXEL 5 & 6-Cylinder Clutch Coil & Bearing
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.