Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
TEST CODE/CONTROL UNIT IDENTIFICATION Function
After selecting a control unit through BMW diagnostic software, an identification page appears. Printout of this page is followed by a test code on printer. This test code contains information which can be used to determine whether correct control unit is installed without having to remove control unit from vehicle. Control unit identification output consists of the following.
- DME Version
- Model Designation/Engine Type
- Oxygen Sensor Control (With/Without)
- Transmission Type [AG - Automatic Transmission (Hydraulic); EH - Automatic Transmission (Electronically Controlled); HG - Manual Transmission]
- Fuel Requirement (Regular, Unleaded, etc.)
- Destination Country (USA)
- DME/Motronic Control Unit Code
- BMW Hardware/Software Part Number
- Bosch Hardware/Software Part Number
- Production Code (If Any)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.