Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Resetting TPM Without iDrive
1992 BMW 318isSECTION Resetting TPM Without iDrive
- Set the tire pressure of all wheels to specification.
- Start engine.
- Move turn signal lever up or down until TPM warning symbol and RESET appears. See Fig 1.
- Press BC button on end of turn signal lever to confirm selection.
- Press and hold BC button for approximately 5 seconds until a CHECK/TICK appears after RESET.
- Drive vehicle. Initialization is automatically completed during the drive, without any feedback issued.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.