Air Bag Control Module: Service and Repair

1987 BMW L7 (E23) L6-3430cc 3.4L SOHC (M30)SECTION Service and Repair

WARNING: Review Service Precautions. Improper handling could cause activation of the airbag(s) and lead to injuries!

REMOVE
- Disconnect battery and cover negative pole or terminal.
- A waiting period of approximately 5 minutes should be observed before beginning electrical work to allow the capacitor charge to dissipate.





- Remove lower steering column trim section.
- Disconnect plug connection for airbag (orange).





- Open glove box.
- Pull off cover (1).





- Lift out retainer (1).
- Pull out pin (2) of both retaining straps.





- Disconnect plugs (orange).
- Unscrew bolts.
- Disconnect ground wire on central ground point.
- Remove control module.

INSTALL
- Install in reverse order.

NOTE: Arrow on module faces forward.

- Check for possible trouble codes.
- Verify proper system operation.



RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.