Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW1987L7 (E23) L6-3430CC 3.4L SOHC (M30)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOXYGEN SENSORSERVICE AND REPAIRMAINTENANCE INTERVAL
1987 BMW L7 (E23) L6-3430cc 3.4L SOHC (M30)
Maintenance Interval
1987 BMW L7 (E23) L6-3430cc 3.4L SOHC (M30)SECTION Maintenance Interval
Oxygen Sensor:
Non-Heated (single wire) Replace At 30,000 Miles
Heated (multi-wire) Replace At 50,000 Miles
Non-Heated (single wire) Replace At 30,000 Miles
Heated (multi-wire) Replace At 50,000 Miles
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.