Overview - MECHATRONIC

2024 Audi S3 PremiumSECTION Overview - MECHATRONIC
Fig 1: Exploded View Of Mechatronic
GWWA34-11633Courtesy of AUDI OF AMERICA, LLC
  1. Transmission
  2. Dual-Clutch Transmission Mechatronic -J743-
  3. Bolt
    • Replace after removing
    • Tightening specification and sequence. Refer to Fig 2.
  4. Seal
    • Replace
  5. Bolt
    • Replace after removing
    • 8 Nm +60Β°
  6. Clip
    • Replace
  7. Transmission Fluid Pan

Dual-Clutch Transmission MechatronicJ743 - Tightening specification and sequence

Fig 2: Dual-Clutch Transmission Mechatronic -J743- - Tightening Specification and Sequence
GWWA34-10990Courtesy of AUDI OF AMERICA, LLC
  • Replace bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps in the sequence shown:

Step Bolts Tightening Specification/Additional Turn
1. -1 to 9- Install all the way by hand
2. -1 to 9- 8 Nm
3. -1 to 9- 45Β° additional turn
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.