Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Bevel Box, Tightening Specification
2024 Audi S3 PremiumSECTION Bevel Box, Tightening Specification
Bevel Box on Dual-Clutch Transmission - Tightening Specification
- Replace the bolts after removing them.
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -arrows- | Install all the way by hand |
| 2. | -arrows- | 40 Nm diagonally |
| 3. | -arrows- | 90° additional turn, diagonally |
Bevel box bracket - tightening specification and sequence
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 and 2- | Install all the way by hand |
| 2. | -1- | 8 Nm |
| 3. | -2- | 8 Nm |
| 4. | -1- | 40 Nm |
| 5. | -2- | 40 Nm |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.