Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Overview - Assembly Mounts
2024 Audi S3 PremiumSECTION Overview - Assembly Mounts
- 1 -
Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING (DNVB) / ENGINE SUPPORT, REMOVING AND INSTALLING (DSFA) .
- 2 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS (DNVB) / OVERVIEW - ASSEMBLY MOUNTS (DSFA) / OVERVIEW - ASSEMBLY MOUNTS (DXHA)
- 3 -
Bracket
- Equipped on some models
- 4 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS (DNVB) / OVERVIEW - ASSEMBLY MOUNTS (DSFA) / OVERVIEW - ASSEMBLY MOUNTS (DXHA)
- 5 -
Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING (DNVB) / ENGINE MOUNT, REMOVING AND INSTALLING (DSFA) / ENGINE MOUNT, REMOVING AND INSTALLING (DXHA) .
- 6, 7 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS (DNVB) / OVERVIEW - ASSEMBLY MOUNTS (DSFA) / OVERVIEW - ASSEMBLY MOUNTS (DXHA)
- 8 - Ground Wire
- 9 -
Nut
- Tightening Specification. Refer to Wiring Diagram.
- 10 -
Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS (DNVB) / OVERVIEW - ASSEMBLY MOUNTS (DSFA) / OVERVIEW - ASSEMBLY MOUNTS (DXHA)
- 11 -
Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING (DNVB) / PENDULUM SUPPORT, REMOVING AND INSTALLING (DSFA) / PENDULUM SUPPORT, REMOVING AND INSTALLING (DXHA) .
- 12 -
Bolt
- Replace after removing
- 130 Nm +90°
- 13, 14 -
Bolt
- Replace after removing
- 60 Nm +90°
- 15 -
Bolt
- Replace after removing
- 60 Nm +90°
- 16 -
Transmission Mount
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING (DNVB) / TRANSMISSION MOUNT, REMOVING AND INSTALLING (DSFA) / TRANSMISSION MOUNT, REMOVING AND INSTALLING (DXHA) .
- 17 -
Bolt
- Replace after removing
- 50 Nm +90°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.