Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Left Seal, Replacing
Special tools and workshop equipment required
- Puller - Crankshaft/Power Steering Seal:T20143
- Seal Installer - Bevel Box:T10298
- Sealing Grease. Refer to the Parts Information.
Procedure
-- Remove the bevel box. Refer to appropriate Service Information .
-- Pry out the seal on the bevel box using the Puller - Crankshaft/Power Steering Seal:T20143/1 or Puller - Crankshaft/Power Steering Seal:T20143/2 .
-- Coat the outer edge and sealing lips on the new seal with transmission fluid.
-- Fill the space between the sealing/dust lip halfway with sealing grease. Refer to the Parts Information.
-- Drive the new seal all the way in using the Seal Installer - Bevel Box:T10298 . Do not tilt it while doing so.
-- Install the bevel box. Refer to appropriate Service Information .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.