Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2023E-TRON S SPORTBACK PREMIUM PLUSREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSGENERAL, TECHNICAL DATA (HEATING, VENTILATION AND AIR CONDITIONING)00 GENERAL, TECHNICAL DATAREPAIR INFORMATIONRADIATOR AND CONDENSER ASSEMBLY
2023 Audi e-tron S Sportback Premium Plus
Radiator And Condenser Assembly
2023 Audi e-tron S Sportback Premium PlusSECTION Radiator And Condenser Assembly
- The radiator and condenser may have small indentations on the fins even when installed correctly. This is not damage. Do not replace the radiator or condenser because of those small indentations.
- Slight deformations on the side condenser securing straps (for example, due to an accident) that result in an unparallel flow from the condenser and radiator can be repaired by pulling the straps back as long as the function/condenser sealing is not impaired. The condenser does not need to be replaced if there are small deformations on the straps.
- A slight bending of the condenser (up to 4 mm) is permissible as long as there is sufficient distance (minimum 4 mm) between the condenser and the radiator and the function/sealing of the condenser is not impaired. The condenser does not have to be replaced if there are slight deformations.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.