Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2023E-TRON S SPORTBACK PREMIUM PLUSREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSAIR CONDITIONING - REFRIGERANT R1234YF SERVICING (REFRIGERANT CIRCUIT)87 AIR CONDITIONINGREFRIGERANT CIRCUITGENERAL DESCRIPTION - REFRIGERANT CIRCUIT COMPONENTSREFRIGERANT CIRCUIT LAYOUT AND FUNCTION
2023 Audi e-tron S Sportback Premium Plus
Refrigerant Circuit Layout And Function
2023 Audi e-tron S Sportback Premium PlusSECTION Refrigerant Circuit Layout And Function
- The condenser and the receiver/dryer are on the high pressure side, and the receiver/dryer or the expansion valve serves as the separator between the high pressure side and the low pressure side.
- High pressure results from the restrictor or expansion valve forming a constriction and causing the refrigerant to accumulate, thus leading to an increase in pressure and temperature.
- Excess pressure is generated if too much refrigerant or refrigerant oil is added, the condenser is contaminated, the radiator fan is faulty, the system is blocked or if there is moisture in the refrigerant circuit (the restrictor or expansion valve freezes).
- Located on the low pressure side are the evaporator, the evaporator temperature sensor and compressor to separate low pressure side (ND gas sides) and high pressure side (HD gas sides).
- A decrease in system pressure can be caused by refrigerant loss, a faulty or blocked expansion or restrictor valve (constrictions), a faulty A/C compressor, or an iced-up evaporator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.