Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2023S6 PRESTIGEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR BODY PANELSHOOD, LIDS
2023 Audi S6 Prestige
Hood, Lids
2023 Audi S6 PrestigeSECTION Hood, Lids
- 55 Hood, Lids
- Safety Precautions
- Hood
- Overview - Hood
- Overview - Release Cable
- Hood, Removing And Installing
- Hood, Adjusting
- Hinges, Removing And Installing
- Hinge, Resetting
- Striker, Removing And Installing
- Gas-Filled Strut, Removing And Installing
- Gas-Filled Strut, Venting
- Impact Guard, Removing And Installing
- Release Cable, Removing And Installing
- Latch, Removing And Installing
- Hook Release Lever, Removing And Installing
- Latch Release Lever, Removing And Installing
- Latch Release Lever Mounting Bracket, Removing And Installing
- Mounting Bracket With Hook Operating Lever Release Cable, Removing And Installing
- Rear Lid
- Overview - Rear Lid
- Overview - Rear Lid Lock Emergency Release Cable
- Overview - Electric Rear Lid Release
- Rear Lid, Removing And Installing
- Rear Lid, Adjusting
- Hinges, Removing And Installing
- Rear Lid Motor Mount, Removing And Installing
- Rear Lid Seal, Removing And Installing
- Roof Frame Trim, Removing And Installing
- Adjusting Buffer, Removing And Installing
- Adjusting Buffer Stop, Removing And Installing
- Gas-Filled Strut, Removing And Installing
- Gas-Filled Strut, Venting
- Tension Spring, Removing And Installing
- Latch, Removing And Installing
- Striker, Removing And Installing
- Rear Lid Closing Assist Motor -V382-, REMOVING AND INSTALLING
- Closing Assist Release Cable, Removing And Installing
- Rear Lid Motor, Removing And Installing
- Rear Lid Drive Units -V444- / - V445- / -VX69- / -VX77-, Adapting
- PREPARE THE Rear Lid Drive Unit -VX69- /Rear Lid Drive Unit 2 -VX77- FOR DISPOSAL.
- Rear Lid Control Module -J605-, REMOVING AND INSTALLING
- Rear Lid Opener Control Module -J938-, REMOVING AND INSTALLING
- Power Rear Lid Opening Sensors -G750- / -G760-, Removing And Installing
- Fuel Filler Door Unit
- Charge Door Unit
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.