Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Module For Left Front Object Detection Radar Sensor, Control Module For Right Front Object Detection Radar Sensor
J533
Data Bus on Board Diagnostic Interface
J1088
Control Module for Left Front Object Detection Radar Sensor
J1089
Control Module for Right Front Object Detection Radar Sensor
J1121
Driver Assistance Systems Control Module
SE
Fuse Panel E
SE11
Fuse 11 on Fuse Panel E
T10c
10-Pin Connector, Black
T10e
10-Pin Connector, Black
T54c
54-Pin Connector, Black
T81a
81-Pin Connector, Black
13
Ground Connection in Engine/Motor Compartment, Right
277
Ground Connection 3 (in Interior Wiring Harness)
382
Ground Connection 17 (in Main Wiring Harness)
655
Ground Connection on Left Headlamp
B277
Positive Connection 1 (15a) (in Main Wiring Harness)
*
Refer to Applicable Wiring Diagram for Fuse Positions
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.