Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Audi e-tron Quattro Premium PlusFACTORY OEM SERVICE PROCEDURE
Controls, Housing
- 34 Controls, Housing
- Safety Precautions
- Shift Mechanism
- Transmission, Removing And Installing
- Front Transmission 0MA, Removing
- Front Motor And Front Transmission 0MA, Separating
- Front Motor And Front Transmission 0MA, Assembling
- Overview - Front Motor
- Action After Replacing Front Motor
- Action After Replacing Front Transmission
- Axial Bearing Shim, Determining
- Angular Contact Ball Bearing Shim, Determining
- Bearing Inner Race For Angular Contact Ball Bearing, Removing And Installing
- Roller Bearing, Removing And Installing
- Front Motor And Transmission 0MA, Assembling
- Rear Transmission 0MB, Removing
- Rear Motor And Transmission 0MB, Separating
- Rear Motor And Rear Transmission 0MB, Separated
- Overview - Rear Motor
- Action After Replacing Rear Motor
- Action After Replacing Rear Transmission 0MB
- Angular Contact Ball Bearing Shim, Determining
- Sun Gear, Removing And Installing
- Bearing Outer Race For Angular Contact Ball Bearing, Removing And Installing
- Rear Motor And Rear Transmission 0MB, Separated
- Transmission Fluid
- Transmission, Disassembling And Assembling
- Special Tools
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
