Calibration Unit: VAS6350A, INSTALLING AND ALIGNING: Notes

2019 Audi S5 Prestige, 2D CoupeSECTION Notes
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2020 Audi S3, 2020 Audi RS 3, 2020 Audi A3 Quattro, 2020 Audi A3, and 2019 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment requiredΒ 

  • Calibration Unit: VAS6350AΒ 
  • Vehicle Diagnostic Tester

After performing repair work on the vehicle, it may be necessary to re-calibrate the rearview camera system. In detail, this is the case after:

  • Rearview Camera -R189- Removal and Installation
  • Replacing Rearview Camera System Control Module -J772-
  • Collision repairs on rear lid
  • Changes to the axle alignment on the rear axle
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.