Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Chip Card Reader Control Module, Removing And Installing: Removing
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Open the glove compartment.
-- Remove the chip card from the Chip Card Reader Control Module -J676-.
-- Slide the Chip Card Reader Control Module -J676- -1- back in the direction of -arrow- until it can be removed from the trim.
-- Release and disconnect the connectors from the Chip Card Reader Control Module -J676- -1-.
-- Remove the Chip Card Reader Control Module -J676-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.