Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition Coils, Removing And Installing: Installing
Install in reverse order of removal while noting the following:
-- Apply a thin bead of silicone paste around the sealing hose for the ignition -arrow-.
Risk of destroying the ignition coil by using an unsuitable lubricant.
- Only use the specified silicone paste.
-- Insert the spark plug connector -2- by hand onto the ignition coil -1- all the way.
- The arrow markings on the spark plug connectors and on the ignition coil must point to each other as shown.
-- Push the ignition coils evenly onto the spark plugs using by hand (do not use any impact tools).
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
Additional procedures depending on the model. Refer to the appropriate service information. .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.