Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2019S5 PRESTIGE, 2D COUPEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2 (REARVIEW CAMERA SYSTEM (2017-19))8 REARVIEW CAMERA SYSTEMREARVIEW CAMERA SYSTEM CONTROL MODULE - J772- CONNECTORSREARVIEW CAMERA SYSTEM CONTROL MODULE - J772- CONNECTORS, FROM MY 2017
2019 Audi S5 Prestige, 2D Coupe
Rearview Camera System Control Module - J772- Connectors, From My 2017
2019 Audi S5 Prestige, 2D CoupeSECTION Rearview Camera System Control Module - J772- Connectors, From My 2017
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2020 Audi S3, 2020 Audi RS 3, 2020 Audi A3 Quattro, 2020 Audi A3, and 2019 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
The Rearview Camera System Control Module - J772- in the Rearview Camera - R189-
- The Rearview Camera System Control Module - J772- in the Rearview Camera - R189-
- 8-Pin Connector - T8ao-
- 2-Pin Connector - T2ps-, to the Information Electronics Control Module 1 - J794-
NOTE:
Unlisted connector terminals are not assigned.
- 8-Pin Connector - T8ao-
1 - Terminal 30
4 - CAN bus high, Infotainment
5 - Terminal 31
8 - CAN bus low, Infotainment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.